General - DemeWiki

vibrating feeder:

Vibrating Feeder is a kind of linear direction feeding equipment.Our vibrating feeder is designed and built to withstand the toughest work in a quarry or mine by matching different applications; This vibrating feeder series is designed particularly for continuous use with any hard and abrasive materials through uniform flow. Vibrating feeder works to continuously and evenly feed lump, particle and powdered materials from hopper to belt conveyer, bucket elevator, screens and crushing machines, etc. Step less regulation is available for SBM’s vibrating feeder to automatically and centrally control the feeding volume. Vibrating Feeder is a commonly used feeding equipment, during the installation and use of vibrating feeder, some essential knowledge must be known. 1. Vibrating feeder is not allowed to be used where is likely to cause injury to persons premises. 2. please install the vibrating feeder device using the hanging device which can withstand the weight of vibrating feeder, must enure that equipment hanging institutions fully carry weight, and have a certain safety factor. So as to avoid the risk of falling of vibrating feeder device. 3. when vibrating feeder is in the hanging and maintenance of the equipment, not allow the person standing in the bottom to operate.so that it may fall, causing no personal injury. 4. maintenance of the feeder must be completely off the power, in order to avoid an electric shock casualty officers. 5. Feeder equipment operation must be connected and ground, in operation every day should be regularly check the wiring and insulation wire skin, anti-shock on the leakage and accidents. 6. when the vibrating feeder load must be running low current operation, so as to avoid damage to equipment, core impact, so under normal circumstances, do not run empty.

raymond mill: Comparing with ball mill, raymond mill features high efficiency, low power consumption, small size, a one-time small investment and widely used in barite, calcite, potash feldspar, talcum, marble, limestone, dolomite, fluorite, lime, activated clay, activated carbon, bentonite, kaolin, cement, phosphate rock, gypsum, glass, insulation materials, etc whose mohs hardness is not greater than 9.3 and humidity is below 6%. Raymond Mill is mainly consist of the milling system, analysis system and dust removal system. Installation: Pre-installation preparation : 1. Before Raymond mill has not yet installed on site, should be properly kept. Exposed surfaces shall be coated with anti-rust oil, and avoid the sun and rain to prevent rusting water body, to establish a maintenance system. 2. Plant and infrastructure should have sufficient height and size of the installation location. The base of raymond mill should be poured with standard cement and steel. After pouring cement a good foundation, you must have the maintenance period of 15 days. 3. should be accompanied by 2 ~ 3 tons lifting tools for installation and maintenance with Raymond mill. 4. After using raymond mill more than 6 months, clean and inspect the central axis of the host system, transmission device, roller device, analysis of oil pools. After that add enough to cope with the various components of lubricants. Raymond mill Operation Flow: Before starting,should check whether all the maintenance doors closed tight, check the crusher jaw plate gap is in line with the feed grain size, adjusting the analytical engine speed should reach approximate finished size requirements. The final start the machine as the order. 1. start bucket elevator; 2. activate the jaw crusher; 3. when there are material silo, start analysis machines;4 to start the air blower;5. start the raymond mill, at the same time start electromagnetic vibrating feeder. shut down the raymond mill machine in the following order: 1. first close the vibrating feeder to feed material;2. about one minute later stop the host;3. blowing the net residual powder then do the cessation of sub-blowers;4. the final close analyzer.